Pre-Assembly
To avoid possible damage to the ST800FI Flat Incline Bench, please follow these assembly steps in the correct order. Be sure to read your Assembly/Owner’s Manual before using your new ST800FI Bench.
Note: During assembly, it is recommended to ensure that all bolts are in place and partially threaded before completely tightening any one bolt.
Unpacking
- Cut the straps, then pull the staples away from the bottom half and lift the top half of the carton off of the bottom.
- The hardware is located in the holes of the associated tubes/brackets.
Tools Required
Step-by-Step Assembly Instructions
1. Rear Bracket
a. Attach the Rear Bracket (2) to the Base Bracket (1).
b. Secure with two M10 x 130 Hex Head Bolts (#30), two Nylon Lock Nut M10 (#39), four Washers φ11 x φ20 x 2 (#43).
Note: Wrench tighten the bolts.
2. Seat Pad
a. Attach the Seat Pad (9) to the Seat Pad Bracket (5) and the Back Pad (10) to the Back Pad Bracket (4).
b. Secure with six M10 x 30 Hex Head Bolts (#31) and six Washers φ11 x φ20 x 2 (#43).
Note: Wrench tighten the bolts.