Powering On
When the CVC800 display is powered up, the all characters on the console will light up. The LCD Data Display Window will show the software version and the total time the climber has been used. After 3 seconds, the console will go to the start-up display and your climber will be ready to use.
Quick Start
To begin working out in Quick Start mode, simply press the Start key after the console has powered on. In Quick Start mode, the Time will count up from zero, and the workload/resistance may be adjusted manually by pressing the up/down keys. Pressing the Stop key once will pause the workout. Press Start to resume the workout. Press the Stop key twice to end the workout.
Connecting to Bluetooth
The Bluetooth connection can be used for either pairing with your phone/tablet or with a wireless Bluetooth chest strap. Please note that the default setting is for connection with the Spirit app. To change the setting to pair with a Bluetooth chest strap, please follow the steps below.
- While the console is in idle mode, press the “Enter” button for 2 seconds. You are now in settings mode.
- The console window will show “APP.” Press either LEVEL UP or LEVEL DOWN to change between “APP” and “BLECHESTSTRAP,” then press STOP/ENTER to return to idle mode.
- The Bluetooth connection will now pair with a Bluetooth chest strap. NOTE: If the machine is powered off/on, the console will automatically revert to the default setting of connecting through the app.
Click here to learn more about connecting to Bluetooth and using third party applications.
Engineering Mode
The CVC800 console has built in maintenance/diagnostic software. The software will allow you to change the console settings from Imperial to Metric, as well as turn off the beeping of the speaker when a key is pressed. To view the available settings, you need to access the Maintenance Menu (may also be called Engineering Mode, depending on the software version).
To access the menu, press and hold down the Start, Stop and Enter keys simultaneously. Keep holding the keys down for about 2 seconds and the console will display “Engineering Mode.” Press the Enter button to access the menu below. Press the up/down keys to navigate the menu, then press the Enter key to select functions (Key Test, Display Test, Functions, Factory Set and Exit).
A. Key Test - Will allow you to test all the keys to make sure they are functioning
B. Display Test - Automatically tests all LCD’s
C. Functions - Press Enter to access settings, use Up/Down keys to scroll
i. ODO Reset- Resets the odometer
ii. Units - Sets the display to read out in Imperial (miles, pounds, feet, etc.) or Metric (kilometers,
kilograms, meters, etc.) display measurements
iii. Sleep Mode - Turn on to have the console power down automatically after 30 minutes of inactivity
iv. Motor Test - Continually runs the tensioning gear motor
v. Manual - Allows stepping of the gear motor
vi. Pause Mode - Turn on to allow 5 minutes of pause, turn off to have console pause indefinitely
vii. Key Tone - Turn on or off the beep sound when a key is pressed
D. Factory Set
E. Exit - Select to exit Maintenance Mode