Pre-Assembly
Unpacking
- Cut the straps, then lift the box over the unit and unpack.
- Carefully remove all parts from the carton and inspect for any damage or missing parts. If parts are damaged or missing, contact your dealer immediately.
- Locate the hardware package. Remove the tools first. Remove the hardware for each step as needed to avoid confusion. The numbers in the instructions that are in parenthesis (#) are the item number from the assembly drawing for reference.
Tools and Parts List
| Tools Included |
| 13/14mm Wrench |
| Combination Wrench |
| 4mm L-Allen Wrench |
| Parts Included | |
| 1 | Main Frame |
| 1 | Aluminum Rail |
| 1 | Front Stabilizer |
| 1 | Rear Stabilizer |
| 1 | Console Mast |
| 1 | Console |
| 2 | Foot Pedals |
| 1 | Power Cord |
| 1 | Hardware Kit |
XRW600 Step-by-Step Assembly Instructions
1. Attaching the Front Stabilizer
| Hardware Needed for This Step | |
| #109 | Flat Washer (3 pcs) |
| #120 | Bolt (3 pcs) |
a. Use the wrench (130) to tighten three bolts (120) together with three flat washers (109) to secure the main frame (1) and front stabilizer (2) together. There is a bolt on each side and one on the front.
2. Attaching the Rear Stabilizer
| Hardware Needed for This Step | |
| #135 | Flat Head Socket Bolt (2 pcs) |
| #109 | Flat Washer (2 pcs) |
| #137 | Spring Washer (2 pcs) |
| #136 | Cap Nut (2 pcs) |
a. Use the wrench (139) to tighten two flat head socket bolts (#135) through where the aluminum track (51) meets the rear stabilizer (3) and secure with two flat washers (#109), two spring washers (#137), and two cap nuts (#136).
3. Attaching the Slide Rail
| Hardware Needed for This Step | |
| #116 | Split Washer (6 pcs) |
| #123 | Bolt (6 pcs) |
a. Attach the other end of the aluminum track (51) to folding end assembly (6) of the main frame (1) and use the Allen wrench (130) to tighten the six bolts (#123) together with six split washers (#116).
4. Attaching the Seat and Pedals
| Hardware Needed for This Step | |
| #121 | Flat Washer (6 pcs) |
| #124 | Phillips Head Screw (4 pcs) |
| #125 | Spring Washer (4 pcs) |
| #129 | Button Head Socket Bolt (6 pcs) |
a. Use the Allen wrench and screwdriver (127) to tighten six button head socket bolts (#129) and six flat washers (#121) to install the left and right pedals (4,5) on the main frame (1). Use the Allen wrench and screwdriver (127) to tighten four Phillips head screws (#124) together with four spring washers (#125) to install the seat (49) onto the seat attaching board (16).