XIC600 Assembly

Pre-Assembly

Unpacking

1. To remove the bike safely from its packaging, cut the straps, then lift the box over the unit and unpack.

2. Carefully remove all parts from the carton and inspect for any damage or missing parts. If parts are damaged or missing, contact your dealer immediately.

3. Locate the hardware package. Remove the tools first. Remove the hardware for each step as needed to avoid confusion. The numbers in the instructions that are in parenthesis (#) are the item number from the assembly drawing for reference. 

Tools and Parts Included

Assembly

XIC600 Step-by-Step Assembly Instructions

1. Stabilizers

a. Gather all hardware needed for this step.
b. Install the front and rear stabilizers with four carriage bolts (#81), four curved washers (#83) and four cap nuts (#82). The front and rear stabilizer are different. Be sure to assemble the stabilizer with the wheels onto the front of the bike.

2. Stabilizer Cover

a. Gather all hardware needed for this step.
b. Install the rear stabilizer cover with two screws (#91).

3. Handlebars and Bottle Holder

a. Gather all hardware needed for this step.
b. Install the handlebars with four bolts (#88), four split washers (#49), and four flat washers (#48). Tighten the bolts securely.
c. Install the bottle holder to the handlebars by loosening the thumb screw, clamp to the handlebars and re-tightening the thumb screw.

4. Pedals

a. Install the left (25-L) and right (25-R) pedals to the crank arms. Note: The left pedal has a reverse threaded bolt and needs to be tightened in a counterclockwise direction. The pedals are identified by either an R or an L stamped into the end of the bolt.

5. Console and Speed Sensor

Cycling Console Battery Installation

1. Remove the battery cover from the back of the computer.
2. Insert 2 AAA batteries into the battery compartment and reinstall the battery cover.
3. When battery working voltage is too low, The “low battery” indicator will show up on the console display indicating it is time to change the batteries.

Speed Sensor Transmitter Battery Installation

1. Remove the battery cover from the transmitter. 
2. Install 2 AAA batteries in the battery compartment and reinstall the battery cover. 
3. When new batteries are installed in the transmitter or console you must perform the synchronizing procedure below for the console to work properly.

Synchronizing the Transmitter to the Console

1. After installing the batteries, and before attaching the console and transmitter to the bike, you must synchronize the two so they can successfully communicate to each other.
2. Press and hold the two keys on the front of the console for about 3 seconds until the display shows "ID - -". 
3. Press and hold the blue button on the transmitter for 3 seconds and release. The console display should show "ID 0." Note: You must press the blue button within 10 seconds after the console is showing "ID - -", otherwise the console will show "ID ER". If the console shows this error then restart the procedure again.
4. It may be necessary to remove and re-install the batteries in both the console and transmitter if you continue to receive the "ID ER" error message.

Installation of the Cycling Monitor Console

1. Install the mounting clamp (2) to the back of the console (1) with the clamp mounting screw (3). 
2. Install and slightly tighten the thumb screw (4) then adjust the console angle for optimal visibility. Once the console is adjusted, continue to tighten the screw until it is securely attached to the handle bar.

Installation of the Speed Transmitter

1. Plug the speed sensor wire into the transmitter (6) and then attach the transmitter (with Velcro pre-attached to the back) to the Velcro half that is pre-installed to the bike frame. The Velcro is mounted to the back side of the chain cover, below the left crank.