Pre-Assembly
Please read before unpacking your treadmill. Serious injury could occur if this treadmill is not unpacked properly.
Unpacking
-
To remove the treadmill safely from its packaging, cut the straps and open the box.
-
Locate the hardware package. The hardware is separated into four (4) steps. Remove the tools first. Remove the hardware for each step as needed to avoid confusion. The numbers in the instructions that are in parenthesis (#) are the item number from the assembly drawing for reference.
Assembly
1. Upright Tubes
a. The right side upright tube (19) has the computer cables pre-installed.
b. Lift the tube off the walking surface and attach it to the base frame. You need to gently pull on the computer cables as you align the upright rube into the bracket on the base frame, taking the slack out so the cable does not get pinched between the tube and the base frame.
c. Assemble one bolt (#104), one split washer (#58), and one flat washer (#59), through the top hole in the retaining plate (21), and corresponding top hole in the upright tube, and screw into the base frame.
d. Now install the other two bolts (#104), and washers (#58, #59) and hand tighten all three. Do not torque the bolts yet until the upper console frame is installed.
e. Install the left upright (18) in the same manner.
2. Console Frame
a. Install the two mounting brackets (3, 4) with the six screws (#108). Refer to the detailed instructions below for this step.
When assembling the console mounting brackets (3, 4), please be sure to slide the brackets all the way towards the back of the console frame before tightening the bolts. Push the mounting bracket all the way towards the back of the console, then tighten the screws.
b. Mount the console frame (5) to the upright tubes (18, 19) with six bolts (#153), six split washers (#58), and six flat washers (#59). Be careful not to pinch the computer wires.
c. Firmly tighten the six bolts (#104) at the bottom of the uprights and install the two end caps (32, 33) with four screws (#73).
3. Console
a. Plug all the connectors into the back of the console.
b. Mount the console (36) to the console frame (5) with two screws (#112) in the top holes and two screws (#110) in the bottom holes in the back side of the console frame.
4. Parallel Bar Handrail
a. Install the eight bolts (#153) and eight flat washers (#59) into the holes on the underside of the frame. Only thread them into the holes two or three turns so the slots in the handrail brackets can slide onto the bolts easily.
b. Slide the handrail onto the bolts and hand-tighten them. Thread the eight bolts (#226) into the sides of the handrails. Once all the bolts are installed, tighten all of them securely.
c. Install the lift bars (192) to the parallel bars ad secure with the knobs (207).
d. Install the rear step (181) by sliding into the receiving tubes under the rear of the desk and secure with the two pins (217). Raising the rear incline may make it easier to line up the holes for the pins.